Lightweight Led Navigation Lights And Anti-Collision; Cabin Lighting - Cub Crafters CC11-100 Maintenance Manual

(2) REMOVAL
(a) Wing tip - Remove the light shield lens and unscrew the bulb. Be careful not to
drop the glass lens or the gasket.
(b) Tail - Remove the lens retainer and lens and unscrew the bulb. Be careful not to
drop the glass lens or the gasket.
(3) INSTALLATION
(a) Wing tip - Insert the bulb and reinstall the lens and the shield.
(b) Tail - Insert a bulb and reinstall the lens and the lens retainer.
(3)
Anti-Collision Lights
(1) GENERAL
The anti collision lights are integral to Navigational lighting system. A breaker switch
on the instrument panel turns it on.
(2) REMOVAL
(a) Refer to Navigational light section
(3) INSTALLATION
(a) Refer to Navigational light section
4

LIGHTWEIGHT LED NAVIGATION LIGHTS AND ANTI-COLLISION

(1) GENERAL
The LED navigation and anti-collision lights are integrated into single solid units.
Two breaker switches on the instrument panel turn them on. The NAV lights switch
controls the Navigation Lights and the STROBE switch controls the anti-collision
lights. The NAV lights must be on for the strobes to activate.
The LED navigation and anti-collision lights are manufactured by Aveo Engineering.
Aveo Engineering offers a free replacement warranty for the lifetime of the aircraft to
which it is installed and registered. This coverage includes all failures except aircraft
crashes.
5

CABIN LIGHTING

The map light is mounted on the right hand interior wing root panel. It is run by its own 4
IEC LR4 alkaline coin cell batteries. The life time is rated for 130 hours.
6.3.19
Page: 4
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Manual number SC10000AMM
Date: 08/02/2010