Inspection; Installation - Cub Crafters CC11-100 Maintenance Manual

(4) INSPECTION

(a) Visually inspect the teeth of the starter gear and starter's housing for damage.

(5) INSTALLATION

(a) Before installing new starter, five 5/16" cap-head bolts must be removed from the
new starter. These bolts are useful during assembly and shipping but must be
removed before installation. The two 6-32 cap-head screws will clear the
accessory case and SHOULD NOT be removed.
(b) Install the starter using new gasket (352179).
(c) Secure the starter using the original hardware except for top bolts (S813-5C28).
Replace flat washers (AN960-516L) and lock washers (MS35337-45). Use new
terminal cover nipple (MS25171-2S) on wire.
(d) Torque the bolts and nuts.
(e) Attach the power cable using the nut and new lock washer. Torque the nut.
6.3.17
Page: 6
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Figure 6.3.17.2: Needle Bearing Removal
CAUTION
Do not over torque the nut on the copper stud.
Manual number SC10000AMM
Date: 08/02/2010