Cub Crafters CC11-100 Maintenance Manual page 260

1. – Detent Holes
4. – Detent Balls and Springs
Refer to Figure 6.3.15.6
(e) Rotate the shaft so the detent balls (4) are between the detent holes (1).
(f) Remove the snap ring (2) holding the handle barrel (3) in the housing.
(g) Carefully pull the barrel (3) out of the housing with your fingers positioned to
catch each set of balls and springs (4).
(h) Remove the small O-ring (5) and the large O-rings (6) then clean the barrel.
(i) Inspect for wear and grooves.
(j) Replace the small O-ring (5) and the large O-rings (6) with new and lube on
installation.
(k) Insert the barrel (3) part way in the housing.
(l) One set at a time, insert a spring with a ball (4) on each end and push the barrel
the rest of the way in.
(m) Secure with the snap ring (2).
(n) Check the operation for positive detent and smooth turning.
(o) Remove the rag.
(p) Reattach the cover, and the handle stop plate with the springs and the handle.
(q) Check and make sure the handle stop is working properly.
6.3.15
Page: 10
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
2. – Snap Ring
5. – Small O-Ring
Figure 6.3.15.6 Fuel Selector Detail
3. – Barrel
6. – Large O-Rings
Manual number SC10000AMM
Date: 04/18/2013