Inspection - Cub Crafters CC11-100 Maintenance Manual

Refer to Figure 6.3.11.14
(a) The control cable rod pivots the mixture control lever on the carburetor. The rod
is held tight by the mixture swivel fitting.
(b) Adjusting the cable rod length at the swivel fitting affects the travel of the mixture
control lever. There should be enough travel in the lever that it reaches the stops
on either extreme of its travel.
(c) The swivel nut should be tightened enough to hold the cable rod firmly but not
enough to shear it or strip the threads.

(4) INSPECTION

(a) Ensure that the mixture lever at the carburetor contacts both stops at either
extreme of its travel. At the same time, there should be no more than ¼" cushion
between the knob and the panel nut in the full rich position.
(b) Inspect to be sure the cable attach swivel does not have excessive play and the
cable is held tightly by the clamp.
(c) Control operation should be smooth. Lubricate with LPS #2 if required.
Manual number SC10000AMM
Date: 10/01/2010
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
6.3.11
Page: 17