Mixture Cable To Carburetor Lever Swivel Attachment - Cub Crafters CC11-100 Maintenance Manual

(a) The mixture cable is fastened to the mixture bracket clamp with a bolt, washers,
and a nut.
(b) The mixture bracket is secured to the engine mount with a bolt, a washer, and a
nut.
The position of the cable housing in the mixture bracket clamp affects the travel
of the knob in relation to the instrument panel. The travel can be adjusted by
loosening the mixture bracket clamp holding the cable housing and sliding the
cable housing in the clamp. Retighten the clamp and check travel.
(c) Be sure the cable housing is held tightly in the clamp after making any
adjustments.

(3) MIXTURE CABLE TO CARBURETOR LEVER SWIVEL ATTACHMENT

1- Cable Rod
4- Mixture Lever
7- Cotter Pin
Figure 6.3.11.14
6.3.11
Page: 16
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
2- Stud
5- Washer
Attachment of Mixture Cable to Carburetor Swivel Arm
3- Swivel
6- Short Castellated Nut
Manual number SC10000AMM
Date: 10/01/2010