Installation - Cub Crafters CC11-100 Maintenance Manual

(2) INSTALLATION

Refer to Figure 6.3.10
(a) Apply thread sealant (EZ TURN Lubricant) to all but the most inner pipe thread
on each elbow but not on the flare fitting threads. Screw the elbows into the oil
cooler. Be very careful to start the threads properly and tighten with the elbow
pointing the proper direction.
(b) Position the oil cooler and install the through-bolt with a washer through the long
spacer tubes between the oil cooler webs.
(c) Position the brace and secure each bolt with a washer and nut
(d) Torque the bolts/nuts.
(e) Attach the oil hose to the elbow on the oil cooler and tighten the fitting while
holding the elbow with a wrench.
Manual number SC10000AMM
Date: 08/02/2010
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Figure 6.3.10.4 Oil Cooler
6.3.10
Page: 9