the engine to idle for a few minutes and shutdown the engine in accordance
with POH procedures.
If the oil pressure does not rise in 30 seconds, stop the engine and determine the
(k)
Visually check inside of cowling for any obvious leaks and correct them as
necessary.
2.2.
OIL SCREEN
(1) REMOVAL
If a spin on oil filter is installed, the oil screen should be desoldered and removed.
(a) Drain the oil (Refer to Section 6.3.10.2.1)
(b) Place a rag below the screen and on top of the muffler shroud to catch the oil.
(c) Remove the bolts that secure the oil screen housing.
6.3.10
Page: 6
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
1 - Gasket
Figure 6.3.10.2
CAUTION
trouble.
2 - Oil Screen
Oil Pressure Screen
NOTE:
Manual number SC10000AMM
Date: 08/02/2010