Removal; Inspection; Installation - Cub Crafters CC11-100 Maintenance Manual

REMOVAL

(1)
(a) Cut the safety wire (1) and remove the brake back plate bolts (2).
(b) Disconnect the brake line (3) from the caliper (4).
(c) Separate the caliper (4) from backing plate (5).

INSPECTION

(2)
(a) Inspect the brake linings for loose rivets, cracks and uneven wear.
(b) The minimum lining thickness is 0.100 inches.
(c) Inspect the calipers for leaks and excessive corrosion.
(d) If leaks are present at the pistons, overhaul the caliper.
(e) Inspect the brake backing plate for cracks or excessive wear.
(f) Replace the parts if their condition so dictates.

INSTALLATION

(3)
(a) Position the brake pressure plate on the caliper so the linings are facing the disc.
(b) Insert the caliper anchor lugs (6) into the backing plate (5) holes.
(c) Connect the brake line (3) and tighten. Make sure the wheel turns freely.
(d) Position the brake back plates (7), insert the bolts (2), and torque to 65-75 in/lbs.
(e) Safety (1) bolts (2) with 0.032 safety wire.
(f) Make sure the wheel turns freely.
6.3.8
Page: 10
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Manual number SC10000AMM
Date: 08/02/2010