Inspection - Cub Crafters CC11-100 Maintenance Manual

(3) INSPECTION

(a) Axle

Visually inspect the axle to make sure there are no cracks or grooves.
(b) Tire and Tube

Visually inspect the tires inside and outside for cuts, uneven or excessive
wear, and penetration by foreign objects.

Visually inspect the inner tube for wear, cuts or cracks. Pay close attention to
the valve stem base.

The tire should be removed when the tread is worn to the base of a groove.
Tires with wear through the top fabric layer can only remain in service long
enough to return to a maintenance base to be replaced.
(c) Wheel Halves

Inspect the wheel halves for cracks or corrosion.
(d) Discs

Inspect the brake disc attachment points for cracking or distortion.

Minimum disc thickness is 0.220 in.
(e) Bearings

Clean all metal parts (including the bearings) in a cleaning solution. Dry all
parts with compressed air.

Inspect the bearing and races for wear or damage. Replace if necessary.
(f) Replace unserviceable parts as required.
6.3.8
Page: 4
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Manual number SC10000AMM
Date: 08/02/2010