Installation Of Tail Wheel And Leaf Springs; Maintenance - Cub Crafters CC11-100 Maintenance Manual

(8) Installation of Tail Wheel and Leaf Springs

See Figure 6.3.7.4
(a) Position the tail wheel springs on the fuselage with long bolt (C) and hold in place
with a washer (B) and a nut (A).
(b) Install the small bolts (G), clamp (D), and small washers (F) with the small nuts
(E) only finger tight.
(c) Insert the bushing (J) into the tail wheel assembly, if they were removed.
(d) Insert the bolt (I) through the bushings and tail wheel assembly.
(e) Hold in place with washer (B) and large area nut (H).
(f) Tighten the large area nut (H) to 270-300 in-lbs.
(g) Tighten the nut (A) to 270-300 in-lbs.
(h) Tighten the small nuts (E) to 70-100 in-lbs.
(i) Reconnect the chain links to the tail wheel arms. The springs and chains should
neither be slack nor have tension when the wheel is centered. It may be
necessary to adjust the number of chain links to achieve this.
(j) Lower the tail section to the ground.
4

MAINTENANCE

No major repair or alterations, as outlined in ASTM F2483, FAR 43, or in this manual are
authorized at this time.
To obtain engineering approvals for any major repairs or alterations, please contact Cub
Crafters at:
Cub Crafters, Inc.
th
1918 South 16 Avenue
Yakima, WA. 98903
Tel: 509-248-9491
support@cubcrafters.com
6.3.7
Page: 18
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Manual number SC10000AMM
Date: 04/27/2009