Tail Landing Gear; Standard Steerable Tail Wheel; Removal Of Tail Wheel And Leaf Springs - Cub Crafters CC11-100 Maintenance Manual

3

TAIL LANDING GEAR

3.1

STANDARD STEERABLE TAIL WHEEL

(1) Removal of Tail Wheel and Leaf Springs

i - Nut
iv - Clamp
vii - Small Bolt (2)
x – Bushing
Figure 6.3.7.2
(a) Lift the tail section of the airplane and rest the fuselage on a bench so the tail
landing gear clears the ground.
(b) Disconnect the chain links from the tail wheel arms.
(c) Remove the front tail spring attach nut (i) and washer (ii).
(d) Disconnect the tail spring clamp (iv) by removing the nuts (v), washers (vi) and
bolts (vii).
(e) To separate the springs from the tail wheel, remove the large area nuts (viii),
washers (ii), and bolts (x).
Manual number SC10000AMM
Date: 04/27/2009
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
ii - Washer (4)
v - Small Nut (2)
viii - Large Area Nut
Standard Tail Wheel and Leaf Spring Installation
iii - Long Bolt
vi - Small Washer (2)
ix - Bolt
6.3.7
Page: 9