Cub Crafters CC11-100 Maintenance Manual page 169

1 - Aileron Control Cable
4 - Wire-Lock Clip
7 - Cotter Pin
10 – Screw
Figure 6.3.6.3
Refer to Figure 6.3.6.3
(b) Attach each aileron control cable turnbuckle fork to the proper aileron horn with
a screw (10), a thin washer (8), a nut (6) and a cotter pin (7).
(c) The aileron travel should be rigged for 18° ± 2° up or down (Refer to section
5.2).
(d) The cable tension must be 40 ± 5 lbs. Refer to the next section, if adjustment is
needed.
Manual number SC10000AMM
Date: 04/27/2009
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
2 – Hinge
5 - Turnbuckle Fork
8 - Thin Washer
Installation of Control Cable on Aileron Horn
3 – Turnbuckle Barrel
6 - Castle Nut
9 – Hinge Arm
6.3.6
Page: 5