Cub Crafters CC11-100 Maintenance Manual page 162

Refer to Figure 6.3.5.10
(c) Connect the elevator horns (8 & 9) to the stabilizer and fuselage, and secure with
the bolt (5), washers (6) and lock nut (7) at the top of the horns.
(d) Attach the lower elevator cable connection (10) on the bottom of the elevator
horns, and secure with the cotter pin (4), through the nut (3) with a washer (2).
Tighten the nut finger tight temporarily.
(e) Repeat on the upper elevator cable connection (10). Torque the nut (7) to 38-43
in. lbs
(f) Check to verify proper elevator movement and routing of cables.
(g) Safety each turnbuckle barrel with two wire lock clips, making sure that each clip
end is locked in the hole. Alternatively, use the single wrap method with 0.032"
stainless steel safety wire.
(h) Reattach the left hand and right hand tail inspection covers.
6.3.5
Page: 14
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Manual number SC10000AMM
Date: 04/18/2013