Refer to Figure 6.3.5.4
(a) Remove left hand and right hand tail inspection covers.
(b) Remove the cotter pin (4), nut (3), and washer (2) on the top side of the elevator
horns (8 & 9).
(c) Carefully remove the clevis bolt (1) to disconnect the upper elevator cable
connection (10).
(d) Remove the cotter pin (4), nut (3), and washer (2) on the bottom side of the
elevator horns (8 & 9).
(e) Carefully remove the clevis bolt (1) to disconnect the lower elevator cable
connection (10).
(f) Remove the lock nut (7), washers (6), and bolt (5) and carefully separate the
elevators from the stabilizer and fuselage.
(2) HORIZONTAL STABILIZERS REMOVAL
Figure 6.3.5.5
(a) Unbolt the upper and lower tail brace wire assemblies.
(b) Unbolt the left stabilizer from the tubes and carefully pull it off.
(c) Carefully slide the right stabilizer, together with the tubes, out of the mounting
points in the fuselage.
6.3.5
Page: 6
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Tail Brace Wires and Elevator Attachment
Manual number SC10000AMM
Date: 04/18/2013