Installation - Cub Crafters CC11-100 Maintenance Manual

(2) INSTALLATION

(a) Position the rudder hinges inline with the hinges on the fin and fasten with two
clevis pins, wire pull bracket (top only), washers, and cotter pin. (Figure 6.3.5.2)
(b) Reconnect the electrical wiring to the lights in the light (3).
(c) Secure each rudder cable fitting (I Figure 6.3.5.3) to a rudder horn with a screw
(II Figure 6.3.5.3), washer (III Figure 6.3.5.3) and nut (IV Figure 6.3.5.3). Make
certain the connections pivot freely and that the rudder is centered when rudder
pedals are inline with each other. Verify full rudder travel to the left and to the
right can be obtained. Make any adjustments at the rear cable attach fitting (I
Figure 6.3.5.3) by changing the hole through which the screw (II Figure 6.3.5.3)
goes through the fitting (I Figure 6.3.5.3). Safety each nut (IV Figure 6.3.5.3)
with a cotter pin (V Figure 6.3.5.3).
I - Cable Fitting
II - Clevis Screw
Figure 6.3.5.3
(d) Hook each tail wheel steering spring (1) to a rudder arm. Lubricate the hinge pins
and pivot points with LPS-2 oil.
(e) Install the rectangular inspection cover.
6.3.5
Page: 4
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
Figure 6.3.5.2: Installation of Clevis Pins at Rudder Hinges
III - Thin Washer
IV - Castle Nut
Attachment of Rudder Cable Fitting
V - Cotter Pin
Manual number SC10000AMM
Date: 04/18/2013