Vortex Generators; Maintenance - Cub Crafters CC11-100 Maintenance Manual

3.

VORTEX GENERATORS

Each wing has 36 vortex generators on the top leading edge. The aircraft is allowed to fly with
the following number of vortex generators missing:

Not more than three vortex generators missing on an aircraft

Not more than three vortex generators missing on a wing

The missing vortex generators must not be next to each other
If a vortex generator should fall off, it must be glued on at the same location as follows:
(e) Ensure that the area where the vortex generator fell off it is dry and free of
grease and dirt.
If the color of the vortex generator does not match the aircraft, it is advisable to paint the
exposed part of the vortex generator prior to installation.
(f) Clean the bottom surface of the vortex generator, removing any old adhesive.
(g) Mask off the rectangular footprint of the vortex generator.
(h) Reattach the vortex generator with LocTite Depend glue.
(i) Remove masking and wipe off excess glue with cleaner
4.

MAINTENANCE

No major repair or alterations, as outlined in ASTM F2483, FAR 43, or in this manual are
authorized at this time.
To obtain engineering approvals for any major repairs or alterations, please contact Cub
Crafters at:
Cub Crafters, Inc.
th
1918 South 16 Avenue
Yakima, WA. 98903
Tel: 509-248-9491
support@cubcrafters.com
Manual number SC10000AMM
Date: 10/01/2010
CUB CRAFTERS, INC.
CC11-100 MAINTENANCE MANUAL
NOTE
6.3.4
Page: 9