Algo 8180 User Manual page 8

will get louder or quieter by the same dB level as the ambient noise measured just prior to
the alert.
Configuration & Provisioning
Configuration can be done through a web interface control panel or by using the program
buttons on the back of the unit. Central provisioning may also be used to allow units to be
pre-configured for a specific server prior to deployment in the field. Configuration files are
automatically downloaded from a server (via TFTP, FTP, HTTP, HTTPS) using DHCP.
Input/Outputs for External Equipment and Devices
The 8180 has a speaker output, an audio output, and dry contact relay that can be set as
input or output. The outputs can be paired with an external speaker, a slave amplifier, or a
visual Alerter (Algo 1127) to enhance notification and alert capabilities. The dry contact
relay can be prompted by any normally open, normally closed switch, Algo 1202 Call
Button, Algo 1203 Call Switch, or Algo 1204 Volume Control Switch.
Note: The internal speaker is disabled when an external speaker is used.
Blue Indicator Light
This LED light is on during initialization, boot, or while active. Ring and Page modes, when
active, will turn the LED on steady. If the optional talkback mode is enabled, the LED will
flash instead (during a page event) to provide a clear indication that the microphone is
active. The LED heartbeat option, when enabled, will flash the LED every 30 seconds as
visual confirmation of PoE power and SIP server registration.
Document 90-00095A
01/24/2019
Page 8
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8180 SIP Audio Alerter (G2) FW 1.7
(604) 454-3792
support@algosolutions.com