Algo 8180 User Manual page 35

o Outbound Ring Limit
o Ringback Tone
o Maximum Call Duration
Action – Make SIP Call with Tone
When the 8180 input is triggered on terminals 5 & 6, a private call can be generated to a
pre-configured phone extension with a pre-recorded message. For instance, a call to a
supervisor's phone notifying about an emergency or intrusion at some location.
Action When Input Triggered:

Extension to Dial

Allow 2

Tone/Pre-recorded Announcement

Interval Between Tone (seconds)

Maximum Tone Duration

Outbound SIP Call Settings:

Outbound Ring Limit

Ringback Tone

Action – Stream Mic Audio
Will stream audio heard over the microphone onto local speaker, as well as over multicast
if configured. "Microphone Always On" will be disabled because this feature should only
trigger from an action and not always.
Action When Tamper Detected (Supervision)
In addition to the main events, the device can be configured with supervision to also
execute one of the above three actions in case the device goes offline due to wiring failure
or after being tampered with. For example, a tone could sound over the speaker(s), or a
private pre-recorded message could be sent to a specified phone extension. The
supervision configuration options will appear once a relay option with supervision is
selected. See the Electrical Specification section for details on supervision detection
circuit.
Microphone Always On
The microphone audio will stream via multicast for monitoring applications. When
microphone streaming is active, the device will act as multicast Master regardless of the
setting in Basic Settings > Multicast. Note that streaming is only available while the device
is idle (it will be interrupted if a Page call is active).
Document 90-00095A
01/24/2019
Page 35
nd Button Press
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8180 SIP Audio Alerter (G2) FW 1.7
(604) 454-3792
support@algosolutions.com