Algo 8180 User Manual page 33

Disabled: No audio
Relay Terminal Function
Can behave as an input or and output relay.
Relay Terminal Function – Output
Relay can trigger external light or other device when specified event occurs
Relay Terminal Function – Input
When triggered by an input relay, 8180 SIP Audio Alerter (G2) can perform actions such
as playing a pre-recorded announcement over the speaker(s), sending the announcement
as a private message to a phone, or initiating a two-way conversation between the
speaker and a phone.
Relay Input Mode
The input relay to the 8180 SIP Audio Alerter (G2)(s) can be prompted by any normally
open or normally closed switch. Algo offers the 1202 Call Button, the 1203 Call Switch, or
the 1204 Volume Control Switch with supervision. Via supervision settings, notification
actions can also be triggered if the input switch is disconnected.
1203 Call Switch
The 1203 Call Switch is a simple contact closure switch with an illuminated
button and supervision capabilities. When used in conjunction with the 8180,
the 1203 can prompt a single action with one-touch, or a continuous action if
the button is held.
Mute Switch
Apply an external switch (short-circuit) across the Relay Input terminals 5 & 6 in order to
mute the speaker. This allows a temporary "disable" switch to control the device if desired,
for example in a boardroom to block paging during important meetings.
Leave the Relay Input terminals open (no-connect) for regular full-volume operation when
in this mode.
1202 Call Button
Document 90-00095A
01/24/2019
Page 33
The 1202 Call Button is a one-touch button for event notification and
response. It can be used with the 8180 for improved customer service,
emergency notification, and non-emergency alerting. The Call Button's
one-touch button can trigger a single or continuous action, which can be
halted via the small cancel/reset button located below the main call
button.
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8180 SIP Audio Alerter (G2) FW 1.7
(604) 454-3792
support@algosolutions.com