Algo 8180 User Manual page 28

Polycom Group Selection Mode
"Single Zone" always broadcasts on one pre-configured Polycom Group. In "DTMF
Selectable Zone" mode, the group is determined by the DTMF selection between 1 and
25.
Note: DTMF Codes for groups 10 and higher start with an "*".
Zone Selection Mode
'Single Zone' always broadcasts on one IP address. 'DTMF Selectable Zone' mode, offers
dynamic zone selection and requires only the master device to have a registered SIP
Extension. The zone definitions can be found in the Advanced Settings > Advanced
Multicast tab.
In 'DTMF Selectable Mode', to page, dial the SIP extension of the master device: ####,
then dial the desired DTMF page zone (e.g. 1, 2, etc.) on the keypad when prompted.
1. Press DTMF Extension 9 for Priority Call
2. Press DTMF Extension 0 (or 8) for All Call
3. Press DTMF Extension 1 for Zone 1...
4. Press DTMF Extension *10 for Zone 10
5. Press DTMF Extension *11 for Zone 11...
Note: DTMF codes for zones 10 and higher start with an "*"
Alternatively, multiple SIP extensions can be registered on the Master device. Each
extension is mapped to a unique zone, allowing zones to be called directly (for instance
from speed-dial keys) without the use of DTMF. See Additional Features > More Page
Extensions tab.
Document 90-00095A
01/24/2019
Page 28
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8180 SIP Audio Alerter (G2) FW 1.7
(604) 454-3792
support@algosolutions.com