Basic Settings Tab - Features - Algo 8180 User Manual

Basic Settings Tab – Features
Ring/Alert Tone
Select WAV file to play when a ring event is detected on the SIP Ring extension. The
WAV file may be played immediately to the speaker from the web interface for test
purposes using the Play, Loop, and Stop buttons. During multicast, the device will
broadcast an audio stream using the Master's selected ring tone.
Note: This is the "Default" tone that will be played if selected for Multicast,
Additional Ring Extension settings.
Ring/Alert Volume
Set speaker volume for SIP ring event. This setting is an amplifier gain control and the
output level will also depend on the levels recorded into the source WAV file played from
memory. This setting is only used for local tones, and not when receiving multicast (see
Page Speaker Volume below).
Document 90-00095A
01/24/2019
Page 23
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8180 SIP Audio Alerter (G2) FW 1.7
(604) 454-3792
support@algosolutions.com