Setup And Installation; Getting Started - Quick Install & Test - Algo 8180 User Manual

Setup and Installation

Getting Started - Quick Install & Test
This guide provides important safety information which should be read
thoroughly before permanently installing the speaker.
1. Connect the 8180 SIP Audio Alerter (G2) to an IEEE 802.3af compliant PoE network
switch. The blue light will remain on until boot up is completed – about 30 seconds.
2. After the blue LED turns off and you hear a tone, press the 'IP Addr' button on the
back of the unit to hear the IP address over the speaker. The IP address may also be
discovered by downloading the Algo Locator Tool to find Algo devices on your
network: www.algosolutions.com/locator
3. Mount the speaker. Summarized instructions are provided in the next section of this
sheet.
4. Access the 8180 web page by entering the IP address into a browser (Chrome, IE,
Firefox etc.) and login using the default password: algo
5. Enter the IP address for the SIP server into the SIP Domain field under the Basic
Settings > SIP tab.
6. Enter the Ring and/or Page SIP extension and credentials. Leave the credentials
blank for either extension if there is no intended use to have both registered.
(Note: The speaker supports multiple Ring, Emergency Alert, and Page SIP
extensions. The Page extension auto-answers for voice announcements. The Ring
and Emergency Alert extensions will play a WAV file over the speaker without
answering.)
7. Make a test call from a telephone to the speaker for one or both extensions. The
Page SIP extension should auto-answer, play the default pre-announce WAV file,
and open a speech path to make a voice announcement. The Ring SIP extension will
play the default WAV file from those available in device memory.
Document 90-00095A
01/24/2019
Page 10
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8180 SIP Audio Alerter (G2) FW 1.7
(604) 454-3792
support@algosolutions.com