NETGEAR EX6200v2 User Manual page 73

• If the extender cannot detect your WiFi network, check to see if your WiFi network is still
working. Make sure that the WiFi router is turned on. If possible, move the extender
closer to the WiFi router.
• If the extender Link Rate LED is red, the WiFi connection between the WiFi router and the
extender is poor. You can establish the best connection with a clear line of sight between
the extender and the WiFi router. Make sure that no physical obstacles exist between the
extender and the WiFi router, and try to move the extender closer to the WiFi router.
If you use Smart Setup, and the extender does not connect to the WiFi router, does not
connect to the Internet, or cannot get an IP address from the WiFi router, Smart Setup
displays a message to notify you that the extender is not configured.
To run Smart Setup again, click the YES button. To manually configure the extender, click the
NO, CONFIGURE MANUALLY button.
AC1200 WiFi Range Extender
FAQs and Troubleshooting
73