Connect Ethernet-Enabled Devices; Use The Extender In Access Point Mode - NETGEAR EX6200v2 User Manual

Connect Ethernet-Enabled Devices

After the extender is connected to your existing WiFi network, you can connect wired devices
to the extender using Ethernet cables. Those devices can then access your existing network
through the extender WiFi connection.
Figure 6. Connect an Ethernet-enabled device to an Ethernet LAN port

Use the Extender in Access Point Mode

You can use the extender as a WiFi access point, which creates a new WiFi hotspot by using
a wired Ethernet connection.
To install the extender as an access point:

1. Attach the stand or the rubber feet.
For more information, see
page 10.
2. Use an Ethernet cable to connect your router to the Ethernet port on the extender.
Ethernet
WiFi router
3. Turn on your extender.
Plug the extender into an electrical outlet. Press the Power button if necessary.
AC1200 WiFi Range Extender
Attach the Stand on page 10 or
Get Started
20
Attach the Rubber Feet
Extender Ethernet LAN port
on