Attach The Stand; Attach The Rubber Feet - NETGEAR EX6200v2 User Manual

Attach the Stand

If you prefer to place the extender in an upright (vertical) position, attach the stand that comes
with the extender. Although the extender functions well in either a horizontal or vertical
position, a horizontal position might give a better performance.
To attach the stand:

1. Place the stand on a flat surface.
2. Hold the extender in an upright position with the
left side of the extender pointing down. (Three
rectangular openings are located on the left
side.)
The top panel of the extender and the three
vertical support posts of the stand must face
the same direction.
3. Lower the extender onto the stand until the
support posts of the stand snap into the
rectangular openings of the extender.

Attach the Rubber Feet

If you prefer to place the extender in a horizontal position, you can attach the rubber feet that
come with the extender.
To attach the rubber feet:

1. Place the extender upside down,
with the red panel facing you. (The
red panel is the bottom.)
2. In each corner, attach a rubber foot
in such a way that it covers the
triangle.
AC1200 WiFi Range Extender
Get to Know Your Extender
10