Safety Precautions; Assembly Instructions - Drive R728RD Manual

assembly instructions

Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.
2. Open frame and slide padded backrest into
frame brackets making sure snap bottoms
protrude through holes.
3. Unscrew tightening knob from handle and
insert handle tube into frame at desired
height lining up holes appropriately. Slide bolts
through holes from
tightening knob until secure.
the inside and screw on

safety precautions

1. Please make sure the Rollator is fully opened,
seat is down and the folding bar under seat is locked
in the down position.
2. Be sure that both knobs are fully tightened and
are at equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the
Rollator. When wheels are locked (see
illustrations for locking
lock bar on rear wheels
turning. If the wheels
locked, please take unit back
adjustment. When locks are released,
the wheels should turn freely.
and releasing locks below),
should prevent wheels from
turn while brakes are
to dealer for