Table of Contents
Advertisement
Item
Plunger
Alligator
Clips
(3)
Plunger
Pincer Clips
(4)
Plunger
Hook Clips
(5)
Case
Foam
Operator's
Manual
* See "IEC/EN 61010-031 Definitions" on p.38 for measurement category definitions.
‡ See "Replacement Parts" on page 32 for information about ordering replacement accessories.
NOTE: The *-NOACC options offer the probe without the accessories.
1.800.561.8187
Description
The clip is designed to securely
grasp thick wires, cables, ground
leads, rails, and screw heads. The
overall length is 153 mm (6.02
inches); the jaw opens to 23 mm
(0.905 inch) max. 4 mm Banana
(female) connector. 1 ea. red/black.
Designed with a long, thin, flexible
stem for attaching to hard-to-reach
test points, the entire body is fully
insulated. The overall length is 161.6
mm (6.36 inch). The pincers can
grab leads, pins and wires up to 4
mm (0.157 inch) in diameter. 4 mm
Banana (female) connector. 1 ea.
red/black.
Designed with a flexible stem to
access deep targets in dense
environments and a 4.5 mm (0.177
inch) hook to attach to wire leaded
parts. The overall length is 157.6
mm (6.20 inches). 4 mm Banana
(female) connector. 1 ea. red/black.
Soft storage case.
Custom foam insert for storage
case.
WARNING. To avoid injury or death due to electric shock, do not handle probe input
leads connected to the Spade Terminals while they are connected to a voltage
source. Do not use Spade Terminals as hand-held accessories; they are meant to
be used as a permanent installation in a test set up.
www.
Safety Rating*
Insulated 1000 V CAT III
Insulated 1000 V CAT II
Insulated 1000 V CAT II
information@itm.com
.com
Operator's Manual
Part Number
QTY
PK-HVA-04
2
PK-HVA-02
2
PK-HVA-03
2
SAC-01A
1
HVD3106
1
924228-00
HVD3106-6M
925473-00
NA
1
7
Advertisement
Table of Contents
