GE JBP23 Use And Care Manual page 23

Plug-In Surface Units
(On Models so equipped)
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, the plug-in surface
units are removable.
RECEPTACLE
TERMINALS
SPIDER
To clean:
MEDALLION
CHROME-PLATED
DRIP PAN/RING
• Wipe around the edges of the sur-
face unit opening in the range top .
Clean the area below the unit.
Rinse all washed areas with a damp
cloth or sponge.
Caution: Be sure all controls are
turned OFF before attempting to
clean under the cooktop or re-
moving the Calrod ® units .
To remove:
• Raise the unit coil opposite the
receptacle . Lift about one inch
above the trim ring and pull away
from the receptacle. Caution: Be
sure the coils are cool before re-
moving a Calrod® unit.
• After removing the plug-in sur-
face unit , lift the drip pan l ring to
clean under the unit.
To replace:
• Place the drip pan l ring in the
surface unit cavity found on top of
the range. Line up the drip pan so
the unit receptacle can be seen.
• Insert the terminals of the plug-
in unit through the opening in the
pan l ring and into the receptacle.
• Guide the surface unit into place
so it fits evenly and fits snugly into
drip pan or trim ring.
Note:
If
your range has separate
trim rings, the drip pan most be
under the trim ring .
CAUTION
• Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
• Do not immerse plug-in surface
units in liquids of any kind.
• Do not bend the plug-in surface
unit plug terminals.
• Do not attempt to clean , adjust
or in any way repair the plug-in
receptacle.
Tilt-Lock Surface Units
Tilt-Lock surface units can be lifted
upward and locked in that position
for cleaning under unit. Be certain
unit is cool before lifting coil up.
After lifting coil unit , remove trim
ring and drip pan to clean under
unit. Clean pan and trim ring as
recommended on Cleaning Chart
on pages 24 and 25.
To Reposition Surface Unit:
• Replace drip pan into recess in
cooktop.
• Put trim ring in place over drip
pan.
• Guide the surface unit into place
so it fits evenly into trim ring. Pan
must be under trim ring .
23
Adjusting Oven Thermostat
Use time given on recipe when
cooking first time. Oven thermo-
stats, in time, may "drift" from the
factory setting and differences in
timing between an old and a new
oven of 5 to 10 minutes are not
unusual. Your oven has been set
correctly at the factory and is more
apt to be accurate than the oven
which it replaced. However, if you
find that your foods consistently
brown too little or too much , you
may make a simple adjustment in
the thermostat (OVEN TEMP)
KNOB.
PULL KNOB OFF OF SHAFT,
LOOK AT BACK OF KNOB
AND NOTE CURRENT SET-
TING, BEFORE MAKING ANY
ADJUSTMENT.
To increase temperature, turn
toward H I. To decrease turn
toward LO. Each notch changes
temperature 10 degrees. Tempera-
ture can be raised by 20 degrees or
lowered by 30 degrees.
I. Pull off knob , loosen both
screws on back of knob holding
skirt of knob firmly. 2. Turn black
handle to move pointer one notch
in desired direction. Tighten screws .
3. Return knob to range, matching
flat area of knob to shaft. Recheck
oven performance before making
an additional adjustment.