Section 4 - Printing; Printing Overview; Figure 60 - Printer - York YK Style H Operation Manual

With optiview control center centrifugal liquid chillers, for electro-mechanical starter, solid state starter and variable speed drive
Hide thumbs Also See for YK Style H:
Table of Contents

Advertisement

FORM 160.76-O2
issue date: 6/15/2015
OKIPOS 441 Serial
Charcoal p/n 62113901
Beige p/n 62113601

FIGURE 60 - PRINTER

PRINTING OVERVIEW

A printer can be connected to the Control Center's
Microboard to print the following reports. The screen
from which each report can be generated is listed in
parenthesis.
• Status ‑ Present system parameters (Printer, Home)
• Setpoints ‑ Present programmed values of all set-
points (Printer, Setpoints)
• Schedule ‑ Present value of programmed daily
schedule (Printer, Schedule)
• Sales Order ‑ Information about SALES ORDER
Screen (Printer, Sales Order)
• History ‑ System parameters at the time of the last
normal stop, last fault while running and last 10
faults, whether running or not (Printer, History)
• Cycling or Safety Shutdown Initiated Print ‑
Snapshot of all system parameters at instant of
shutdown. Automatically occurs if printer is con-
nected at time of shutdown.
JOHNSON CONTROLS

SECTION 4 - PRINTING

• Adaptive Capacity Control (ACC) Surge Map
‑ System conditions at instant all surge points
were mapped. (Compressor Motor Variable Speed
Drive applications; requires SERVICE access lev-
el) (Printer, ACC)
• Trend ‑ Prints a snapshot of the existing TREND
Screen data or prints new data collected after the
TREND PRINT key is pressed.
The printer can be permanently connected to the Con-
trol Center or connected as required to produce a report.
If permanently connected, a DATA LOGGING feature
can produce a status report automatically, beginning at
an Operator selected start time and occurring at an Op-
LD16572
erator selected interval thereafter.
The following figures are examples of the different
print reports. Solid State Starter application print re-
ports shown. Electro-Mechanical Starter and Variable
Speed Drive reports are similar but print parameters
applicable to those devices.
• Figure 64 - Status on Page 194
• Figure 65 - Setpoints on Page 196
• Figure 66 - Schedule on Page 198
• Figure 67 - Sales Order on Page 198
• Figure 68 - History on Page 200
• Figure 69 - Security Log on Page 202
• Figure 70 - Trend on Page 202
• Figure 71 - CUSTOM Screen on Page 202
• Figure 72 - Adaptive Capacity Control New Map
point Report on Page 203
• Figure 73 - Adaptive Capacity Control Existing
Map points Report on Page 203
4
189

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents