Teledyne Lecroy Quantumdata 780E Quick Start Manual

Teledyne Lecroy Quantumdata 780E Quick Start Manual

Video generator / protocol analyzer for hdmi, displayport & hdbaset testing

Advertisement

780E Video Generator / Analyzer – Quick Start Guide
Page 1
780E Video Generator / Protocol Analyzer
for HDMI, DisplayPort & HDBaseT Testing
Quick Start Guide
Rev: B1
September 13, 2018
P/N 68-00231 - Rev. B1

Advertisement

Table of Contents
loading

Summary of Contents for Teledyne Lecroy Quantumdata 780E

  • Page 1 780E Video Generator / Analyzer – Quick Start Guide Page 1 780E Video Generator / Protocol Analyzer for HDMI, DisplayPort & HDBaseT Testing Quick Start Guide Rev: B1 September 13, 2018 P/N 68-00231 - Rev. B1...
  • Page 2 1 Overview of 780E Protocol Analyzer / Generator ™ This section provides an overview of the Teledyne LeCroy quantumdata 780E Video Generator / Analyzer. The 780E provides HDMI, HDBaseT and DisplayPort and Tx and Rx ports and digital audio output ports. The HDMI ports support 600MHz operation.
  • Page 3 780E Video Generator / Analyzer – Quick Start Guide Page 3 780E Front Edge 780E Rear Edge What is in the 780E shipping box? The 780E instrument shipping container includes the items listed in Table 1-1 below: Table 1-1: 780E Shipping Box Contents Item Description Part No.
  • Page 4: Video Interfaces

    780E Video Generator / Analyzer – Quick Start Guide Page 4 2 Physical Interfaces of the 780E Protocol Analyzer / Generator This section describes the administration, video and audio interfaces on the 780E test instrument. Video Interfaces Table 2-1 below describes the video interfaces on the 780E test instrument, these interfaces are used to render test patterns for testing consumer electronic HDTVs and computer displays.
  • Page 5: Digital Audio Interfaces

    780E Video Generator / Analyzer – Quick Start Guide Page 5 Digital Audio interfaces Table 2-2 below describes the distinct digital audio interfaces supported on the 780E Multi-Protocol Analyzer / Generator. Note audio is supported through the HDMI, DisplayPort, HDBaseT interfaces; however the table below only lists the separate digital interfaces.
  • Page 6: Sd Card Slot

    780E Video Generator / Analyzer – Quick Start Guide Page 6 SD Card Slot The 780E test instrument is equipped with an SD card slot. The SDCard slot is used for storing and loading bitmaps, reports, and for recovery in the event of a failed upgrade. Note: 780E Image above shows the front edge with SD card slot.
  • Page 7: General Operation

    780E Video Generator / Analyzer – Quick Start Guide Page 7 3 General Operation This section describes power up, power usage and general operation. Power Considerations The 780E has a rocker style power switch on the back panel. Refer to the photo below. The 780E is supplied with the Part No 25-00110 12V DC power supply and charger as well as a part number 30A00400A03 line cord.
  • Page 8: Home Screen

    780E Video Generator / Analyzer – Quick Start Guide Page 8 3.3.1 Home Screen The Home screen is shown below. 3.3.2 Status Bar The 780E has a status bar on the bottom of the screen. This status bar is present no matter what screen you are viewing. The items in the status bar are described in the Table 3-1.
  • Page 9 780E Video Generator / Analyzer – Quick Start Guide Page 9 Video Resolution Status Indicates the video resolution on the HDMI In port. This includes:  Horizontal Active in pixels  Vertical Active in pixels Frame rate  Video Identification Status Indicates the CEA video identification code.
  • Page 10 780E Video Generator / Analyzer – Quick Start Guide Page 10 AVMute Indicates the status of: HDCP Status AVMute active/inactive status  +5V Status  HDCP active/inactive status  +5V present/not present status Running Basic Tests on Sink Devices This Quick Start Guide does not cover detailed procedures for most common operations. However, the following information will get you started conducting some of the more common operations for testing sinks.
  • Page 11 780E Video Generator / Analyzer – Quick Start Guide Page 11 3. To select the video test pattern, touch select the Pattern button from the Home menu as shown below: 4. To enable and disable 3D and specify the 3D format, touch select the 3D button from the Home menu as shown below: September 13, 2018 P/N 68-00231 - Rev.
  • Page 12 780E Video Generator / Analyzer – Quick Start Guide Page 12 5. To select the audio format, touch select the Audio button from the Home menu as shown below: September 13, 2018 P/N 68-00231 - Rev. B1...

Table of Contents