Wlan Module - HP 15-BQ0 Series Maintenance And Service Manual

WLAN module

Description
Intel Dual Band Wireless-AC 7265 802.11 AC 2×2 WiFi + Bluetooth 4.2 Combo Adapter (non-vPro)
Realtek RTL8822BE 802.11 AC 2×2 WiFi + Bluetooth 4.2 Combo Adapter
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the system board (see
Remove the WLAN module:
1. Turn the system board upside down with the front facing toward you.
2. Remove the WLAN module by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
Bottom cover on page
Battery on page
System board on page
WLAN modules are designed with a notch to prevent incorrect insertion.
29).
31).
42).
Component replacement procedures
Spare part number
901229-855
924813-855
47