Power Connector Cable (Dc-In) - HP 17 Maintenance And Service Manual

Power connector cable (DC-in)

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the power connector cable:
1. Remove the two Phillips M2.5×6.0 screws from the right display hinge (1), and then rotate the hinge up
from on top of the power connector (2).
2. Disconnect the power connector cable from the system board (3).
3. Remove the power connector cable from the computer (4).
Reverse this procedure to install the power connector cable.
54 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Optical drive on page
Bottom cover on page
Battery on page 38).
32).
36).
Spare part number
L22528-001