Optical Drive Board - HP 17 Maintenance And Service Manual

Optical drive board

Description
Optical drive board
Optical drive board cable
Before removing the optical drive board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the optical drive board:
1. Disconnect the cable from the ZIF connector on the optical drive board (1).
2. Remove the two Phillips M2.0×3.0 screws (2), and then remove the board from the computer (3).
Reverse this procedure to replace the optical drive board.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Optical drive on page
Bottom cover on page
Battery on page 38).
32).
36).
Spare part number
L22540-001
L22524-001