Siemens SIPART PS2 Operating Instructions Manual page 38

Installing/mounting
4.1 Basic safety instructions
It is possible to damage the cover gasket
If the cover gasket is not positioned correctly in the groove of the base plate, it could be
damaged when the cover is mounted and screwed tight.
● Therefore make sure that the gasket is seated correctly.
Open cable inlet or incorrect cable gland
Danger of explosion in hazardous areas.
● Close the cable inlets for the electrical connections. Only use cable glands or plugs which
Exceeded maximum ambient or process media temperature
Danger of explosion in hazardous areas.
Device damage.
● Make sure that the maximum permissible ambient and process media temperatures of
Unsuitable compressed air
Device damage. As a general rule, the positioner must only be operated with dry and clean
compressed air.
● Use the customary water separators and filters. An additional dryer is required in extreme
● Use dryers, especially if you operate the positioner at low ambient temperatures.
38
WARNING
WARNING
are approved for the relevant type of protection.
WARNING
the device are not exceeded. Refer to the information in Chapter "Technical data
(Page 283)".
CAUTION
cases.
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB