Initm' Initialization (Manual); Application Parameters 6 To 55; Sdir' Setpoint Direction - Siemens SIPART PS2 Operating Instructions Manual

9.3.1.5

'5.INITM' Initialization (manual)

Possible settings:
Purpose:
Description:
Factory setting:
9.3.2

Application parameters 6 to 55

9.3.2.1

'6.SDIR' Setpoint direction

Possible settings:
Purpose:
Factory setting:
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
● NOINI
● no / ###.#
● Strt
Use this parameter to start the manual initialization process.
1. Select the "Strt" setting.
2. Then press the
If the positioner has already been initialized and if the "4.INITA" and
"5.INITM" values are set, it is possible to reset the positioner to the
non-initialized status. To do this, press the
seconds.
NOINI
● riSE
● FALL
This parameter is used to set the setpoint direction. The setpoint
direction is used to reverse the direction of action of the setpoint.
● Rising (riSE): A higher value at the setpoint input results in
opening of the valve.
● Falling (FALL): A higher value at the setpoint input results in
closing of the valve.
The setpoint direction is primarily used for the split-range mode and
for single-acting actuators with the safety setting 'uP'.
riSE
9.3 Description of parameters
button for at least 5 seconds.
Parameter assignment
button for at least 5
157