Additional Precautions - Drive RTL12031KDR User Manual

8. To assemble backrest, insert support tube into
backrest support by depressing push pin and
sliding into backrest tube. Repeat for second support
tube (Figure 5).
figure 5
9. Insert backrest into base by depressing push pins
and sliding support tubes through both receptacles.
Note: Backrest must go through both sets of
receptacles to become secure (Figure 6).
figure 6
Rev.2.12.11.15
NOTE: Back support is reversible to accommodate left
or right tub entry. You can also change the seat depth
of your transfer bench by pushing the pins under the
seat and sliding the tubes forward until the pins lock
into place.
8. Place legs with the large suction cups into bath tub.
adjusting leg height
1. To adjust leg height, remove U-Clip adjustment
hole, set leg to desired height and return U-clip
into adjustment hole. Make sure U-Clip clicks
into place. Repeat for remaining legs.
NOTE: Make sure all legs are set to the same height.
2. To be sure legs are locked into place, push down or
pull up on legs.

additional precautions

1. Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE. Contact
dealer/carrier for further instructions.
2. Make certain that the snap buttons fully protrude
through the same respective holes of each leg
extension. This will ensure that the leg extensions
are securely locked in position and an even height is
achieved.
3. Ensure ALL screws, nuts and/or bolts are tightened.
4. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
5. All four leg extensions with rubber tips MUST touch
the floor simultaneously at all times.
6. DO NOT stand on the bench.
NOTE:
To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water. Wipe
seat dry after each use.