Drive RTL12031KDR User Manual page 2

assembly instructions
Weight Capacity: 400 lbs (181 Kg)
1. Remove contents from carton.
2. Lay both transfer bench seat sections upside down on
a flat surface.
3. Slide smaller seat section into larger section by
depressing the brass push pins and inserting into the
receptacles. Snap buttons will pop out when secure.
(Figure 1)
figure 1
4. Remove black top from 4 leg receptacles.
5. Attach leg with the large suction cup (marked "A") by
depressing the brass push pin and inserting into the
receptacle with the matching "A". Repeat for second
leg (Figure 2).
figure 2
Rev.2.12.11.15
6. Attach leg with small rubber tip (marked "B") by
depressing brass push pin and inserting into the
receptacle with matching "B". Repeat for second leg
(Figure 3).
figure 3
7. Turn transfer bench right-side-up. Attach armrest
by depressing brass push pins and sliding into the arm
receptacle on the side of the bench. Make sure the
arm arcs outward, not inward (Figure 4).
figure 4