SolarEdge StorEdge Installation Manual page 92

If an error message is displayed during the test, use the following table to resolve the error.
Error
Bat 1 charge failed
Bat 1 discharge failed
Low SOE
Battery comm. error
Turn switch to On
To check the meter and inverter:
1. Verify that AC is ON.
2. Check the meter (installed in export or consumption position, CT arrows point to the grid):
a. Turn the inverter ON/OFF switch to OFF.
b. Connect loads on one of the measured phases.
c. Press the external LCD light button to display the Import or Consumption meter status screen
(depending on the connection point), and check that the import or consumption energy (Energy
[Wh]) is greater than 0 (may take a few minutes, depending on the loads size):
I m p o r t
S t a t u s :
P o w e r [ W ] :
E n e r g y [ W h ] :
d. Press the LCD light button to display the Export meter status screen, and check that the Export
power is equal to zero. I f it is not zero, check the CT direction on all connected phases.
3. Turn the inverter ON/OFF switch to ON.
4. Turn the StorEdge Connection Unit switch to ON.
5. While the modules are exposed to sunlight (PV system is connected to the grid and the inverter is
producing power), press the inverter LCD light button to display the power status screen, and check
that the grid AC output (Vac) increases to 220-240V, and the total AC output power produced (Pac):
V a c [ V ]
2 4 0 . 7
P _ O K :
. . . . . . . . . . . . . . . . .
StorEdge Inverter Installation Guide MAN-01-00390-1.1
Check that the power and communication cables between the battery and
inverter are properly connected.
Check that the power and communication cables between the battery and
inverter are properly connected.
Charge the battery to 20 percent SOE at least.
Check that the communication cables between the battery and inverter are
properly connected.
Turn the inverter ON/OFF switch to ON.
M e t e r
< O K / E r r o r # >
x x x x x . x
X X X X X . X
V d c [ V ] P a c [ W ]
w 3 7 1 . 9 2 3 4 9 . 3
X X X / Y Y Y < S _ O K >
O N
Chapter 8: System Configuration
Solution
89