Setting Charge/ Discharge Profile + Backup Power - SolarEdge StorEdge Installation Manual

a. Select Energy Manager  Storage Control. The following is displayed:
B a c k u p
A C
b. Select Backup Rsvd and set the required level of reserved energy as percentage of the battery
capacity:
For backup power + Smart Energy Management - according to user requirement
o
For backup-only - according to battery manufacturer recommendation, if provided.
o
If you set the Backup Rsved to a value other than 0%, the following is displayed:
B a c k u p
G r i d
A C
c. Select Grid Charge and one of the following options:
Enable: Charge from both PV and grid to reach backup reserved value

Disable: Charge from PV only to reach backup reserved value


Setting Charge/ Discharge Profile + Backup Power

In this mode, you first set the system to charge/ discharge profile ( for time-of-use arbitrage) and the level
of charging the battery from AC. Then, you set up the level of stored energy to be reserved for backup.
To set up Charge/ Discharge Profile (TOU) + Backup Power:
1. Access the Energy Ctrl. menu as described above.
2. Select Time of Use.The Energy Manager screen changes to display the following:
L i m i t
E n e r g y
S e t C a l e n d a r
S t o r a g e
3. From the Energy Manager menu select Set Calendar. The following screen is displayed, showing
options for calendar setting:
S e r v e r
L o a d
4. Do one of the following:
To load a time-of-use table from the monitoring platform, refer to

https://www.solaredge.com/sites/default/files/storedge_charge_discharge_
profile_programming.pdf .
To load a time-of-use table from the SolarEdge SD card (contact SolarEdge to

obtain it), insert the card to the slot labeled "Card" on the communication board
and select Load SD. From the displayed list select the directory and the table
(filename).
StorEdge Inverter Installation Guide MAN-01-00390-1.1
R s v d < N / A >
C h a r g e L i < N o n e >
R s v d < 2 0 % >
C h a r g e < E n >
C h a r g e L i < N o n e >
C o n t r o l < D i s >
C t r l < T O U >
C o n t r o l
S y n c < D i s >
S D < N / A >
Chapter 8: System Configuration
87