Chapter 8: System Configuration; Upgrading The Inverter Firmware Version - SolarEdge StorEdge Installation Manual

Chapter 8: System Configuration

Chapter 8: System Configuration
This chapter describes how to configure your StorEdge system by setting up the communication
between the system components and setting up the required a pplication. To use the StorEdge
applications, the communication board firmware (CPU) version must be 3.xxxx and later on all SolarEdge
inverters at the same site . The latest firmware version is available for download at
http://solaredge.com/storedge/firmware.

Upgrading the Inverter Firmware Version

Upgrade the inverter firmware using a MicroSD card with the latest firmware version downloaded from
the above link .
To upgrade the inverter firmware:
1. Make sure that:
The inverter has been activated using the activation card supplied with the inverter

The inverter ON/OFF switch is OFF

The AC voltage to the inverter is OFF

2. Remove the inverter cover.
80
StorEdge Inverter Installation Guide MAN-01-00390-1.1