Wi-Fi Status; Gsm Status; Communication Ports Status - SolarEdge StorEdge Installation Manual

Wi-Fi Status

Wi-Fi Status
This screen describes the Wi-Fi configuration:
I P : 1 9 2 . 1 6 8 . 2 . 1 1 9
G W : 1 9 2 . 1 6 8 . 2 . 1
S S I D : x x x x x x x x
R S S I : < L / M / H / - >
IP: The DHCP provided address

GW: The gateway IP address

SSID: Service Set Identifier - the name of a wireless local area network (WLAN). All wireless devices on a

WLAN must employ the same SSID in order to communicate with each other.
RSSI: The receive signal strength indication of the closest Wi-Fi in the SolarEdge system. L = low, M =

medium, H = high and - = no signal.
GSM Status
If a GSM Plug-in is connected, this screen replaces the Server status screen:
S e r v e r : C e l l
S t a t u s :
M N O : < x x x x x x x >
< E r r o r
Server: The method of communication to the SolarEdge monitoring platform. Should display Cell.

Status: Displays OK if the inverter established a successful physical connection to the modem.

S_OK: The last communication to the SolarEdge monitoring platform was successful (appears if the

inverter is connected to the platform). If S_OK is not displayed, refer to Status Screens - Operational
Mode on page 63.
MNO: The mobile network operator name

Sig: The signal strength, received from the modem. A value between 0-5, (0 = no signal;

5 = excellent signal)
Error message: per communication connection status failure


Communication Ports Status

R S 4 8 5 - 1 < S E > < S
Z i g B e e
##: The total number of slaves detected on the specific port

Dev: The type of device that was configured to a specific port (based on the port's functionality), as

follows:
SE: SolarEdge device (default)
o
LGR: Non-SolarEdge logger
o
MLT: Multiple devices, such as meters and batteries
o
HA: Home automation devices (for Smart Energy)
o
66
< S _ O K >
< O K >
S i g : 5
m e s s a g e >
D e v P r o t # #
> < - - >
< S E > < M P S > < - - >
StorEdge Inverter Installation Guide MAN-01-00390-1.1