Display
Select Display to set the following:
T e m p e r a t u r e
L C D
O n
T L M
O n
Temperature: Select Celsius or Fahrenheit units.
LCD On Time <30>: The number of seconds that the LCD backlight is ON after pressing the LCD light
button. Set a value within the range of 10-120 seconds.
TLM On Time <15>: The number of minutes that the LCD backlight is ON while viewing the Telemetry
window. Set a value within the range of 1-120 minutes.
Maintenance
Select Maintenance to set the following options:
D a t e
a n d
R e s e t
C o u n t e r s
F a c t o r y
F W
U p g r a d e
D i a g n o s t i c s
G r i d
P r o t e c t i o n
B o a r d
R e p l a c e m e n t
O p t i m i z e r
Date and Time: Set the internal real-time clock. If connected to the SolarEdge monitoring platform,
the date and time are set automatically and only time zone should be set.
Reset Counters: Resets the accumulated energy counters that are sent to the SolarEdge monitoring
platform
Factory Reset: Performs a general reset to the d efault device settings.
FW Upgrade: Perform a software upgrade b
an_inverter_using_micro_sd_card.pdf.
Diagnostics: Displays the Isolation Status and optimizers status screens. Refer to
www.solaredge.com/files/pdfs/application_note_isolation_fault_
troubleshooting.pdf .
Standby Mode: Enables/disables Standby Mode - for remote commissioning.
Grid Protection: Available in specific countries. Enables viewing and setting grid protection values.
Optimizer Conf.: Opens t he Rapid Shutdown menu, to enable/disable PVRSS.
Board Replacement: Backs up the system parameters; Used during board replacement according to
the instructions supplied with replacement kits.
StorEdge Inverter Installation Guide MAN-01-00390-1.1
< C >
T i m e
< 3 0 >
T i m e
< 1 5 >
T i m e
R e s e t
C o n f .
y using an SD card. Refer to upgrading_
Chapter 6: User Interface
61