Chapter 6: User Interface; Lcd User Buttons - SolarEdge StorEdge Installation Manual

Chapter 6: User Interface

Chapter 6: User Interface

LCD User Buttons

Four buttons are located inside the inverter above the LCD panel and are used for controlling the LCD
menus, as shown below:
Use the four user buttons to control the LCD panel menus:
Esc: Moves the cursor (>) to the beginning of the currently displayed parameter; goes to the previous

menu, and cancels a value change with a long press (until Aborted is displayed).
Up (1) and Down (2): Moves the cursor from one menu option to another, moves among the

characters of a displayed parameter, and toggles between possible characters when setting a value.
: Selects a menu option and accepts a value change with a long press (until Applied is displayed).

The LCD screen displays status information of the system and various menus for configuration options.
The LCD panel and buttons are used during the following processes:
Operational mode: The LCD panel allows checking for proper system o peration. Refer to Status

Screens - Operational Mode on page 63 for a description of this option.
Setup mode: Upon installation, an installer may perform basic configuration .

Error messages: In the event of a problem, an error message may be displayed on the LCD panel.

For more information, refer to http://www.solaredge.com/sites/default/files/se-
inverter-installation-guide-error-codes.pdf and Inverter C onfiguration – Setup Mode on
page 51.
50
Figure 34: LCD Internal menu buttons
StorEdge Inverter Installation Guide MAN-01-00390-1.1