SolarEdge StorEdge Installation Manual page 47

Step 1: Activating the System
C P U : 0 0 0 3 . 1 9 x x
C o u n t r y : E S P
6. If required, perform the following additional steps before closing the inverter cover:
Country settings or inverter configuration using the internal LCD user buttons – refer to

Country and Grid on page 57.
Communication options connection – refer to Setting Up Communication to the Monitoring

Platform on page 70.
StorEdge application configuration - refer to System Configuration on page 80.

7. Close the inverter cover b y tightening the screws with a torque of 9.0 N*m/ 6.6 lb*ft. For proper
sealing, first tighten the corner screws and then the two central screws. The following figure
illustrates recommended order:
8. Close the StorEdge Connection Unit internal cover: Attach the cover and secure it by tightening the
four screws with a torque of 1.2 N*m / 0.9 ft.*lb.
9. Make sure the AC Bypass switch in the StorEdge Connection Unit is switched to the left (position 1).
10. Make sure the backed-up loads AC breaker i n the StorEdge Connection Unit is UP.
11. Close the StorEdge Connection Unit external cover: Attach the cover and secure it by tightening the
six screws with a torque of 1.2 N*m / 0.9 ft.*lb.
44
Figure 32: Tightening order of the screws
Figure 33: StorEdge Connection Unit
StorEdge Inverter Installation Guide MAN-01-00390-1.1