Inverter Interfaces - SolarEdge StorEdge Installation Manual

Inverter Interfaces

The following figure shows the inverter connectors and components, located at the bottom of the
inverter.
Two communication glands, for connection of inverter communication options. Each gland has

three openings. Refer to Setting Up Communication to the Monitoring Platform on page 70 for more
information.
LCD light button: Pressing this button lights up the LCD for 30 seconds. In addition, you can press

this button to view inverter status screens and access configuration menu options, as described
Configuring the Inverter Using the LCD Light Button on page 54.
ON/OFF switch: Turning this switch ON (after the power optimizers are paired with the inverter)

starts the operation of the power optimizers, enables power production and allows the inverter to
begin exporting power to the utility grid/backed-up loads. Turning it OFF reduces the power
optimizer voltage to a low safety voltage and inhibits exportation of power. When this switch is OFF,
the inverter control circuitry remains powered up.
LCD panel: displays inverter information and configuration parameters

LCD LEDs: Three LEDs indicate the following inverter statuses:

Color Description
Green Power production
Module communication and
Yellow
inverter shutdown
Red
All LEDs turn on while the inverter is being configured.
StorEdge Inverter Installation Guide MAN-01-00390-1.1
Figure 5: Inverter Interfaces
Blinking - Standby mode. The inverter is in Standby mode until its
working voltage is reached. The inverter then enters Production
Off - The inverter is not producing power. This may be during Night
mode, when the inverter ON/OFF switch is OFF or when an error
o
On - There is an error. Refer to Troubleshooting on page 92 for
Fault
Chapter 3: Installing the Inverter
Functionality
On - The inverter is producing power.
mode and produces power.
occurs.
Blinking:
Monitoring information is being received from a power
optimizer.
The inverter is being shut down.
o
more information.
Blinking - The inverter is being shut down.
19