SolarEdge StorEdge Installation Manual page 2

Revision History
Revision History
Version 1.1 (July 2018)
Clearance for three phase inverters installed side-by-side, outdoors: 5 cm / 2"

Power optimizer clearance - no clearance is required on the mounting bracket side

Addition of reference to troubleshooting undetected devices application note

Torque for grounding using the equipment grounding bus-bar: 3.4 N*M / 3 0 lb-in

Update of product names

Addition of possibility to use compatible connectors from third-party manufacturers

Recommendation to mount the power optimizer in a location protected from direct sunlight

Updated warning about sealing unused power optimizer input connectors

Max distance between the battery and inverter is 70 ft / 20m

Removal of StorEdge Connection Unit Replacement

Addition of caution - installation in saline environment

Update regarding use of extension cables in power optimizer installation guidelines

Removal of recommendation to connect the battery and set DIP switch when the battery is on the

floor, for easier access
Addition of l ow battery SOE troubleshooting

Addition of important safety feature: restart behavior functionality

Addition of battery connection via conduit

Addition of link to the Designer web page

Addition of battery charge/ discharge self-test and troubleshooting

In Power Optimizer Installation chapter:

Removed reference to racking models and their grounding methods
o
Removed mentioning of tracker
o
In inverter Installation chapter:

Added a caution about not altering the StorEdge Connection Unit enclosure: SolarEdge does not
o
permit opening or puncturing the StorEdge Connection Unit in any location other than the pre-
defined drill guide locations, or otherwise altering the construction of the enclosure, as this may
compromise safety and will void the warranty.
Connection to/from the Connection Unit:

450V DC to BAT connector (DC- and DC+ connections) corrected in the connection diagram
o
Added a diagram of LG battery connection to inverter with 3 DIP switches
o
In Configuration Menu Options:

Power Control section:
o
Removed Phase Balance link and info

Added link to P(Q) diagram application note

Maintenance section:
o
Added links to application notes (Upgrading the inverter using SD card; Isolation fault

troubleshooting; Arc fault detection)
Removed Optimizer Conf

In System Configuration chapter:

2
StorEdge Inverter Installation Guide MAN-01-00390-1.1