SolarEdge StorEdge Installation Manual page 10

NOTE
The symbol
this manual.
NOTE
A SolarEdge inverter may be installed in a site with a generator, however must not operate at the same
time as the generator. Operating an inverter and a generator simultaneously will void the warranty.
SolarEdge requires installing a physical or electronic interlock, which will prevent the generator and
inverter from operating simultaneously. Interlock procurement, installation, maintenance and support
are the responsibility of the installer. Damage to the inverter due to incorrect interlock installation or use
of an interlock that is incompatible with the SolarEdge system will render the SolarEdge warranty
invalid.
NOTE
The following warning symbols appear on the inverter warning label:
WARNING!
Shutting off the AC breaker does not disable the DC voltage inside the inverter. To obtain safe DC
voltage, turn off the inverter ON/OFF switch and the StorEdge Connection Unit ON/OFF switch.
WARNING!
Before operating the system, ensure that the inverter has been grounded properly.
WARNING!
When handling the battery, adhere to all manufacturer safety instructions.
WARNING!
The battery should be powered OFF before and during wiring. Turn
OFF:
a. The circuit breaker switch
b. The auxiliary power supply switch
To reconnect power, turn ON:
a. The auxiliary power supply switch
b. The circuit breaker switch
CAUTION!
This unit must be operated under the specified operating conditions as described in the technical
specifications supplied with the unit.
StorEdge Inverter Installation Guide MAN-01-00390-1.1
appears at grounding points on the SolarEdge equipment. This symbol is also used in
Risk of electric shock
Risk of electric shock from energy stored in the capacitor. Do not remove cover
until 5 minutes after disconnecting all sources of supply.
Hot surface – To reduce the risk of burns, do not touch.
IMPORTANT INVERTER SAFETY INSTRUCTIONS
7