SolarEdge SE50K Installation Manual page 60

7. Connect the cable RJ45 connector to the RJ45 port of the Ethernet switch or router.
You can connect more than one inverter to the same switch/router or to different switches/routers,
as needed. Each inverter sends its monitored data independently to the SolarEdge monitoring
platform.
NOTE
There are no LED indicators on the Ethernet connector, if the inverter is not communicating with
the monitoring platform through a LAN refer toTroubleshooting Communication on page 71.
Extended Power Commercial Inverter Installation Guide MAN-01-00402-1.0
Chapter 6: Setting Up Communication
59