Maintenance
From the main menu, select Maintenance to configure various system settings, as described below.
Maintenance
Date and Time
Temperature
Reset Counters
Factory Reset
Arc Fault Circuit
Interrupter (AFCI)
Firmware Upgrade
Load / Save
Configuration
Diagnostics
Standby Mode
Grid Protection
Board Replacement
Date and Time: Set the internal real-time clock. If connected to the SolarEdge monitoring platform,
l
the date and time are set automatically and only time zone should be set.
Temperature: Set the temperature units to use: Celsius or Fahrenheit
l
Reset Counters: Resets the accumulated energy counters that are sent to the SolarEdge monitoring
l
platform
Factory Reset: Performs a general reset to the d efault device settings.
l
Arc Fault Circuit Interrupter (AFCI): Enables or disables production interruption in case of arc-fault,
l
sets the reconnection mode, and enables or disables manual AFCI self-test.
Refer to https://www.solaredge.com/sites/default/files/arc_fault_detection_
application_note.pdf .
Firmware Upgrade: Perform a software upgrade.
l
Load / Save Configuration: Enables saving or loading s ystem parameters from one
l
inverter to another.
Extended Power Commercial Inverter Installation Guide MAN-01-00402-1.0
Chapter 5: Activating, Commissioning and Configuring the System Using SolarEdge
›
Sep-7 2017
09:45am
›
Celsius
›
›
Enabled
›
Automatic
Reconnect
›
›
›
›
Disable
›
›
41