Service And Maintenance; Maintenance - Siemens SIPART PS2 series Hardware Installation Manual

Service and maintenance

4.1

Maintenance

These instruments do not normally require any routine maintenance.
NOTICE
Caution
Before disassembling the unit, make sure all air pressure to the unit is turned off.
Customer/Product Support
This section provides the Internet site addresses, e-mail addresses, telephone numbers, and
related information for customers to access Siemens product support.
When contacting Siemens for support:
● Please have complete product information at hand:
– For hardware, this information is provided on the product nameplate (part number or
– For most software, this information is given in the Help > About screen.
● If there is a problem with product operation:
– Is the problem intermittent or repeatable? What symptoms have been observed?
– What steps, configuration changes, loop modifications, etc. were performed before the
– What status messages, error messages, or LED indications are displayed?
– What troubleshooting steps have been performed?
– Is the installation environment (e.g. temperature, humidity) within the product's
● A copy of the product Service Instruction, User's Manual, or other technical literature
should be at hand. The Siemens public Internet site (see the table) has current revisions
of technical literature, in Portable Document Format, for downloading.
● To send an instrument to Siemens for repair, request a Return Material Authorization
(RMA).
Support is available through an online Support Request service; a link is provided in the
table below.
Venting Gauge Block Installation Instructions
Hardware Installation Manual, 12/2014, A5E34388399-AD
model number, serial number, and/or version).
problem occurred?
specified operating parameters? For software, does the PC meet or exceed the
minimum requirements (e.g. processor, memory, operating system)?
NOTICE
Important
An instrument must be thoroughly cleaned (decontaminated) to remove any process
materials, hazardous materials, or blood born pathogens prior to return for repair. Read
and complete the Siemens RMA form(s).
4
19